| 004-16836-00 |
氧化银参考材料 |
Reference materials for Temperature-Programmed Reduction (TPR) Analysis |
| 004-25549-00. |
1 / 8IN x 1/4英寸管OD黄铜减速器 |
Reducer fittings for regulators |
| 004-25938-00. |
1/16in PEEK Ferrule |
For mounting the sample thermocouple in the same 1/8-in. fitting as the quartz thermocouple sheath |
| 004-25940-00 |
1/8英寸窥视套圈 |
For the quartz thermocouple sheath,which mounts through a 1/8th inch fitting |
| 004-32164-01 |
4in x 6in Bag of Quartz Wool |
|
| 004-32187-00 |
用于处理热部件的棉绒布手套 |
|
| 004-33601-00 |
Expansion Kit that adds an additional outlet to the gas regulator with a maximum of 1000 psig |
Kit Includes: Fittings and Instructions |
| 004-33601-01 |
Expansion Kit that adds three additional outlets to the gas regulator with a maximum of 1000 psig |
Kit Includes: Fittings and Instructions |
| 004-33601-02 |
扩展套件，为燃气调节器增加了三个附加插座，最多3500 psig |
Kit Includes: Fittings and Instructions |
| 004-54609-00. |
Wide Bristled Brush |
For cleaning sample tubes |
| 004-54805-00. |
Extraction Tool |
Facilitate the extraction of quartz wool from reactor |
| 004-61064-00. |
600ml杜瓦尔 |
Used for the cold trap slurry. Dewar can also hold liquid nitrogen for BET analysis |
| 004-61602-00. |
1ml校准注射器 |
For manual gas injections up to 1ml. Used when calibrating the loop volume or for manual calibration of reactive gases |
| 004-61602-01 |
用于1ml校准注射器的3个替换注射针 |
Includes 3 spare needles |
| 004-61604-00 |
10ml校准注射器 |
用于手动气体注入高达10ml。校准环路体积或用于对反应气体的手动校准时使用 |
| 004-61604-01 |
用于10ml校准注射器的3个替换注射针 |
Includes 3 spare needles |
| 004-62150-326 |
1500 psig Gas Regulator with CGA 326 Fitting for N2O |
|
| 004-62150-350 |
1500 psig气体调节剂，CGA 350适用于CO或H2 |
|
| 004-62150-540 |
1500 psig Gas Regulator with CGA 540 fitting for O2 |
|
| 004-62150-580 |
1500 psig Gas regulator with CGA 580 fitting for Ar, He, or N2 |
|
| 004-62150-590 |
1500 psig Gas Regulator with CGA 590 fitting for 10% O2 in He |
|
| 004-62200-58 |
100 psig Gas Regulator with CGA 580 fitting for N2, He, Ar, and Kr |
|
| 004-62230-32 |
30 psig Gas Regulator with CGA 320 fitting for CO2 |
|
| 004-62230-35 |
30 psig Gas Regulator with CGA 350 fitting for CO, H2 |
|
| 004-62230-54 |
30个PSIG气体调节器，CGA 540适用于O2 |
|
| 004-62230-58 |
30个Psig气体调节器，CGA 580适用于N2，HE，AR和KR |
|
| 004-62230-59 |
30 psig Gas Regulator with CGA 590 fitting for Ultrapure Air |
|
| 008-42001-00. |
Analytical Methods in Fine Particle Technology |
A comprehensive resource of information on particle analysis. This hardbound text describes theory, instrumentation, and applications pertaining to chemisorption and temperature-programmed reactions, as well as other analytical methods used in the characterization of catalysts and other materials. |
| 021-00000-00 |
Model 021 Liquid Nitrogen Transfer System |
为了更安全和易于将液氮转移成较小的样品露珠。包括47-L杜瓦，多洛和带100cm放电线的泵。通用电气输入。 |
| 029-00000-00 |
冷冻室II |
Provides seamless temperature control for fully automated temperature programmed reduction, desorption and reaction analysis. Allows furnace system to hold sample at approximately -120 °C. |
| 201-25818-00 |
6ft Stainless Steel Gas Inlet Line Assembly |
Includes stainless steel tubing, with ferrules and nuts (1/8-in. male fitting to connect to analyzer on one end, 1/8-in. female fitting to connect to regulator on opposite end) |
| 201-25818-01 |
16英尺不锈钢气体入口线组件 |
Includes stainless steel tubing, with ferrules and nuts (1/8-in. male fitting to connect to analyzer on one end, 1/8-in. female fitting to connect to regulator on opposite end) |
| 280-32800-00 |
Foam Support for Weighing Sample Tube |
|
| 290-25842-00 |
Gas Sampling Assembly |
采样与校准注射器兼容 |
| 290-25846-00 |
6英尺铜气体吸入管路总成 |
Includes copper tubing, with ferrules and nuts (1/8-in. male fitting to connect to analyzer on one end, 1/8-in. female fitting to connect to regulator on opposite end) |
| 290-25846-01 |
16ft Copper Gas Inlet Line Assembly |
Includes copper tubing, with ferrules and nuts (1/8-in. male fitting to connect to analyzer on one end, 1/8-in. female fitting to connect to regulator on opposite end) |
| 290-62600-00 |
0.5ml注入环 |
|
| 290-62601-00. |
1ml注入环 |
|
| 290-62602-00. |
5ml注入环 |
|
| 291-31801-00 |
半盖600ml冷陷阱杜瓦 |
Two needed per 600ml dewar |
| 291-34005-00 |
KwikCool |
提供炉子的快速冷却，降低分析时间并提高产量。在室温下使用压缩空气 |
| 291-53904-00 |
Sample Thermocouple |
Shaped to enter the reactor measureing the sample temperature during the experiment |
| 292-32801-00. |
Protective Shelf Mat |
|
| 292-33015-01 |
Cirrus 2 200 AMU Mass Spectrometer |
Stand alone unit |
| 292-46101-00 |
卷云设施tion and Training for U.S.A. or Canada |
|
| 292-46102-00 |
卷云设施tion and Training for Europe |
|
| 292-46103-00. |
亚洲和所有其他国家的卷心安装和培训 |
|
| 295-33015-00. |
Cirrus 2 200 AMU Mass Spectrometer |
200 AMU mass spectrometer connects directly to a dedicated port on the AutoChem II 2950 for detection and identification of low concentrations of condensable and/or reactive gases. |
| 295-33021-00 |
KwikCool Vortex |
Supplies chilled cool air by a Vortex technique intended for rapid cooling of the furnace. It is not a temperature control device |
| 295-33640-00 |
Cirrus 3 200 AMU质谱仪 |
200 AMU mass spectrometer connects directly to a dedicated port on the AutoChem II 2950 for detection and identification of low concentrations of condensable and/or reactive gases. |
| 295-33640-CR. |
Corrosion Resistence Cirrus 3 200 AMU Mass Spectrometer |
200 AMU mass spectrometer connects directly to a dedicated port on the AutoChem II 2950 for detection and identification of low concentrations of condensable and/or reactive gases. Enhanced Chemical Resistant (ECR) Unit |
| 295-42801-00 |
Autochem 2950操作员手册 |
Printed manual with binder |
| 295-53801-00 |
炉汇编 |
|
| 930-54603-00. |
Narrow Bristled Brush |
For cleaning sample tubes |
| 295-25801-00. |
Stainless Steel Sample Tube |
|
| 004-27041-00 |
样品管20微米过滤器玻璃料 |
Placed inside the o-ring at the small stem outlet of the sample tube |
| 291-25819-00 |
Large Stem Retaining Nut for Sample Tube |
|
| 004-25011-01 |
-011 Kalrez Oring for Large Stem on Stainless Steel Sample Tube |
|
| 295-25817-00 |
Ferrule Set on Large Stem of Stainless Steel Sample Tube |
Two-part Ferrule for the large stem of the sample tube |
| 291-25816-00. |
Small Stem Retaining Nut for Sample Tube |
|
| 295-25818-00 |
Ferrule Set on Small Stem of Stainless Steel Sample Tube |
Two-part Ferrule for the small stem of the sample tube |
| 004-25465-00 |
-010 Kalrez O形圈用于样品管上的小茎 |
|
| 291-61702-00 |
石英样品管 |
U tube reactor |
| 295-25825-01 |
小茎石英样品管密封的第2部分 |
|
| 295-25825-02 |
小茎石英样品管密封的第1部分 |
|
| 004-25474-00 |
-013 Kalrez Oring for Large Stem on Quartz Sample Tube |
|
| 295-25826-01 |
大茎石英样品管密封的第1部分 |
|
| 295-25826-02 |
Part 2 of Large Stem Quartz Sample Tube Seal |
|
| 004-32004-00 |
石英样品管入口的塞子 |
样品管塞以限制样品管在仪器之外时将样品暴露在空气中 |
| 004-16247-00 |
窥探 |
用于气体流量计和气体泄漏检查 |
| 004/16825/00 |
Platinum Alumina Reference Material |
For checking pulse chemisorption |
| 004-32604-08 |
样品管出口的塑料盖 |
Cap for quartz sample tube to limit sample exposure to air when sample tube is outside of the instrument |
| 029/33030/00 |
冷冻室安装软管支架 |
支架有助于将冷冻室软管固定到炉子上，而不会在炉子上旋转管子 |
| 292-34013-00. |
25.75欧姆FE-NI-AU探测器组件 |
Complete TCD wired detector 25.75, ±0.75 Ohms @ 70 ±3 °F, with gold coated Fe-Ni filaments |
| 004/16848/00 |
草酸钙一水合物参考材料 |
For Check Temperature Programmed Desorption |